Table of Contents
Advertisement
list ip addresses
Displays the IP address for each active IP network. It lists the following
information:
list ip defaultroute
Displays default gateway IP routers, which act as default routes for IP packets
destined for remote hosts unknown to the OfficeConnect Gateway. All
unspecified routes are automatically sent to this gateway. A default route gateway
specified with a higher metric acts as the primary default route gateway and a
second default route gateway with a lower metric acts as the secondary default
route gateway. It lists the following information.
Configured default routes
Address
112.23.44.34
112.23.44.34
list ip networks
Displays all the IP networks you previously defined statically using the add ip
network command and any dynamic networks created with a PPP connection to
the OfficeConnect Gateway. It also lists:
address - IP address of the interface
Bcast Algo - Algorithm used to determine which address to broadcast
representing the entire network. Choices are:
1 - the IETF standard: nnn.nnn.nnn.255 (default)
0 - the BSD standard: nnn.nnn.nnn.000
Reassembly Max Size - maximum allowable size of packet that can be
reassembled from a fragmented packet
Interface - interface this IP address uses to connect to the system. Values
displayed are internal, loopback, or eth:1.
IP addresses
Bcast
address
Algo
2.2.2.2/A
1
127.0.0.1/A
1
123.145.134.140/2
1
2
address - IP address of the default route
Mask - subnet mask of the default route
Gateway - IP address of the gateway router
Metric - hop count to the gateway
State - status of the default route
Name - network designation
Prot - IP protocol only
Int - name of the LAN interface this network runs on: eth:1, loopback,
internal, sdsl:1/<PVC name>, atmaal:1/<PVC name>
Reassembly
Max Size
3464
3464
3464
Mask
Gateway
255.255.255.25
112.23.45
2
.34
255.255.255.25
112.23.45
2
.32
List Commands 12-11
Interface
internal
loopback
eth:1
Metric
State
3
State
4
State
Advertisement
Table of Contents
