18
Overview
Creating a PPPoE
Client Session
Add a User
add user <user_name>
Set the Remote IP
address
set network user
<user_name> ip
remote_ip_address
<ip_address>
Add the Datalink
add datalink ppp
interface
<interface_name> user
<user_name>
PPP
E C
O
OMMANDS
This section describes the PPPoE (Point-to-Point Protocol over Ethernet) commands
accessible from the CLI. The Point to Point Protocol over Ethernet (PPPoE) standard
helps access providers manage their broadband service delivery, and it can also
improve the ease of use for DSL customers.
To use PPPoE you must create a PPPoE Client session by performing the following
steps:
Add a User
Set the Remote IP address
Add the datalink
To add a user, use the add user <user_name> command. This command has the
following parameters:
password <user_password>
max_sessions_per_host <number>
local_ip_address <ip_address>
send_password <user_password>
network_service <pppoec_fr_rfc1490 | pppoec_fr_rfc1483 |
pppoec_atm_rfc1483>
type network
Use the set network user <user_name> ip remote_ip_Address <ip_address>
command to set the PPPoE client's remote IP address.
Use the add datalink ppp interface <interface_name> user <user_name>
command to add the datalink between the PPP interface and the user.