Show Commands
show user <name>
Type - type of configured user. See the add user command for more
information.
USERS
User Name
curly
default
administrator
This section describes the show user and show
The show user <name> command displays the parameters defined for the
specified user.
settings
all_settings
settings - Displays settings for the specified user with the exception of
disabled IP, Tap Status and Tunnel Type parameters.
all_settings - Displays all settings for the specified user.
The type of information displayed depends on the type of user you specify. You
can issue the list users command to see which users are defined, and what type(s)
user each is. An example of the information displayed for a user is shown in the
following table. Note that this user may not be typical. Defaults are indicated by
(D). set maximum_local_users <number>
INFORMATION FOR USER: joeadmin
Status:
Type:
Expiration:
DNIS Re Authentication:
Special Xon Xoff Flow Control
NAT Option:
Intelligent NAT State:
Intelligent NAT default
workstation:
Policy Filename:
Telnet Options:
Input Filter:
Output Filter:
Session Timeout in seconds:
Idle Timeout in seconds:
Tap Status:
Tap Format:
Login
Network
Service
Service
TELNET (D)
PPP (D)
TELNET
PPP
TELNET (D
PPP (D
ACTIVE
LOGIN
NETWORK
TUNNEL
MANAGE
NONE
REAUTH_ANY
DISABLED
INVALID
DISABLED
0.0.0.0
None
(D)
(D)
0 (D)
0 (D)
DISABLED
ASCII
Show Commands
4-5
Status
Type
ACTIVE
LOGIN
DIALOUT
MANAGE
INACTIVE
NETWORK
ACTIVE
LOGIN
MANAGE