Table of Contents
Advertisement
12-20 C
12: IP R
HAPTER
OUTING
set ip pool <pool_name>
set ip route <IP_hostname
or network address>
C
OMMANDS
Send Compatibility - Controls the selection of destination MAC and IP
addresses. It is enabled by default. When enabled, broadcast address is used;
when disabled, multicast address is used.
RIP V1 Receive - Controls the receipt of RIP version 1 updates. When RIP
version 1 is the selected routing protocol, this policy is enabled by default,
which means RIP version 1 packets are received. When RIP version 2 is chosen,
this policy is enabled by default, meaning RIP version 1 packets are received.
RIP V2 Receive - Controls receipt of RIP version 2 updates. When RIP v1 is the
selected routing protocol, this policy is enabled by default, which allows RIPV1
packets to be received. When RIP version 2 is selected, this policy is enabled by
default, allowing RIPV2 packets to be received. RIPV2 is backward compatible.
Silent - This flag tells RIPv2 not to send updates. It is disabled by default
Modifies IP pool parameters set using the add ip pool command. This command
has the following parameters:
initial_pool_address <IP_address/subnet>
max_unused_addrs <0-4096>
route [aggregate | no_aggregate |multiple_aggregate]
size <1-4096>
state [public | private]
.
Parameters
Description
<pool name>
Designation of the IP pool. The limit is 16 ASCII characters.
initial_pool_address/s
First IP address to be assigned from the specified pool, in the format
ubnet_mask
nnn.nnn.nnn.nnn, with or without a mask specifier. The mask specifier
can be 'A', 'B', 'C', 'H', or a numeric value from 8 to 30 (32 for host)
that describes the number of one bits in the mask. If you do not specify
a mask, OfficeConnect Gateway will generate the natural netmask
from the initial_pool_address.
max_unused_addrs
This parameter specifies the maximum number of IP address that will
be wasted (unused) when multiple aggregate IP routes are created.
This field is only valid if route type is multiple_aggregate. The range is
0-4096.
route
Broadcasts the pool as a single network (aggregate), individual host
routes (no_aggregate), or multiple networks (multiple_aggregate). The
default is No_aggregate.
size
Number of allowable IP addresses. Class C values exceeding x.x.x.255
will increment to x.x.1.1. The default is 1. The range is 1-4096.
state
Type of pool created. A public pool allocates IP addresses to any caller
not assigned a pool; a private pool is limited to specified users. The
default is Public.
Modifies the IP route created using the add ip route command. This command
has the following parameters:
gateway <host name or IP station address>
metric <1-15>
Advertisement
Table of Contents
