3Com OfficeConnect 3C100XF Cli User's Manual page 174

20-2 C 20: N
HAPTER ETWORK
S C
ERVICES OMMANDS
The parameters of the add network service command are described in the
following table:.
Parameters Description
<service_name> Name of this type of service. The limit is 32 ASCII characters.
close_active_ Indicates whether or not to close any active connections when a service
connections is disabled by the disable network_service command. The default is
False.
data Ancillary Data. This field contains server-specific configuration data. See
table below for configurable ancillary data values for TELNET.
enabled Optional. Indicates whether the network is enabled (YES) or disabled
(NO). When you add a network service, it is enabled by default.
server_type Designates the type of service being offered. Services currently available
are:






socket Port the server listens on. For TFTP and TELNET, it is the TCP or UDP port
number. Socket numbers are the joined sender's (or receiver's) IP
address and service type's port number. The maximum is 65535. The
range is 0-65535.
The following table shows the configurable values for network service, which are
specified with the data parameter.
Ancillary Data
Values Description
auth On indicates that login/password authentication should be performed on
incoming connections.
Format: auth= [on | off]
The default is on.
drop_on_hangup Value specifying whether the TCP session is dropped after modem hangs
up. Off allows connection to remain active.
The default is off.
login_banner ASCII string sent to a client when connection is made. It must be quoted
and offset by backslashes if spaces are included in the string. Specify
carriage return after login banner with login_banner=string\r\n\.
The format is login_banner=string
The default is none.
login_prompt ASCII string specifying the login prompt sent during authentication. It must
be quoted and offset by backslashes if spaces are included in the string.
Specify a carriage return after the login banner with
login_banner=string\r\n\.
The format is login_prompt=string
The default is login:.
service_type Indicates whether the service offered is modem sharing or manage.
Modem sharing service connects a client to multiple modems.
Manage service connects a client to the command line, to manage the
system. Applicable only to TELNET servers; you can't use ClearTCP to
access the system for management.
Format: service_type=manage, dialout
The default is manage.
SNMPD - Daemon supports SNMP. Uses UDP.
TFTPD - Daemon supports file transfer service. Uses UDP.
TELNETD - Daemon supports TELNET, to the CLI. Uses TCP.