Table of Contents
Advertisement
25-10 C
25: SNMP C
HAPTER
Show Commands
show snmp
show snmp
community_pool
<pool_name>
show snmp
trap_community_pool
<name>
show snmp counters
OMMANDS
This section describes the following Set-related SNMP commands:
show snmp
show snmp community_pool <pool_name>
show snmp trap_community_pool <name>
show snmp counters
The show snmp command displays whether the SNMP Authentication Traps
setting is enabled (or disabled) to indicate authentication-failures. The default is
enabled.
Also see the disable snmp authentication traps and enable snmp
authentication traps commands.
The show snmp community_pool <pool_name> command displays the IP
address of the specified SNMP community address pool.
It lists the following information:
Community Pool
shrewsbury
132.113.122.188
Also see add snmp community_pool <pool_name>.
The show snmp trap_community_pool <name> command displays the
specified SNMP trap community and IP addresses of associated trap communities
defined using the add snmp trap_community <name> command. It lists the
following information:
Community Pool sayhey
2.2.2.2
2.2.2.3
2.2.2.4
The show snmp counters command displays many SNMP statistics. The
information is organized into Input and Output Counters categories.
Input Counters:
Packets - number of SNMP packets received
Bad Versions - SNMP messages for an unsupported SNMP version
Bad Community Names - SNMP messages which used an unknown SNMP
community name
Bad Community Uses - SNMP messages which represented an SNMP
operation not allowed by the SNMP community named in the message
ASN.1 Parse Errors - sum of ASN.1 or BER errors
Too Big Errors - SNMP PDUs for which the value of the error-status field is
`tooBig'
Advertisement
Table of Contents
