18-2
C
18: PPP
E C
HAPTER
O
PPPoE Commands
Add Command
add pppoe service_name
<name>
Delete Command
delete pppoe
service_name <name>
Enable Command
enable pppoe on
interface <interface_name>
Disable Command
OMMANDS
The following table identifies the PPPoE commands that can be used after a PPPoE
session has been created.
Command
Command Name
Type
Add
add pppoe service_name <name>
Delete
delete pppoe service_name <name>
Enable
enable pppoe on interface <interface_name>
Disable
disable pppoe on interface <interface_name>
Set
set pppoe
List
list pppoe
list virtual connections
Show
show pppoe [counters | settings]
During the discover stage of the PPPoE protocol, the PPPoE client may request a
connection with the OfficeConnect Gateway indicating the service name that it
requires. The service name is typically the name of the ISP or any Quality of Service
(QOS) parameters.
Presently the service names are just strings with no QOS significance attached. The
client may send a service name as a NULL string indicating that any service is
acceptable in which case no service names need to be configured in the
OfficeConnect Gateway. If the client request contains a non-null service name in
the request, then the same name has to be configured in the OfficeConnect
Gateway.
Removes the designated PPPoE service name.
This command enables the specified interface to send and receive frames carrying
the new ether-type defined by the PPPoE protocol.
max_sessions <number>
max_sessions_per_host<number>