Delete Command; Enable Command; Disable Command; List Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

Delete Command

delete network service
<service_name>

Enable Command

enable network service
<service _name>

Disable Command

disable network service
<service_name>

List Commands

list network services
To configure a TELNET service to offer CLI access on port 6666, doing
authentication upon connect (default) and dropping the connection on hangup,
type the following:
add network service CLI_access server_type telnetd socket 6666 data
drop_on_hangup=on
The delete network service command deletes the specified network service
from the list of available services. You must use disable network service before
deleting the service
You can see which services are available and active using the list available
servers and list network services commands.
The enable network service command enables the network service that you
previously defined with the add network service command.
You can see which services are currently defined and their state using list
network services.
The disable network service command disables a network service, such as
TELNET or TFTP.
If close_active_connection was specified as TRUE in the add network_service
command, then all active connections are closed when the service is disabled.
This section describes the following List commands:
list network services


list available servers


The list network services command displays all network services you defined
using the add network service command. This command lists the following
information:
Name - name of service. Values displayed are TELNET (default) or TFTP


(default),
Server Type - type of network server. For example, TFTPD (TFTP daemon)


Socket - TCP port number used (you assign or by default) by the service


Close - reveals whether all connections close when you disable this service.


TRUE or FALSE. See add network service command for details.
Admin Status - the status you have requested for this service. Enabled or


disabled. See the add network service command for details.
Name Server Type
1 TELNETD
DATA: modem_group="all",auth=off,service_type=dialout
Delete Command
Socket Close
61 FALSE
20-3
Admin Status
Enabled