Table of Contents
Advertisement
Disable Commands
disable ppp
acct_for_abnormal_disc
disable ppp
address_field_
compression
disable ppp
protocol_field_
compression
disable ppp receive_accm
disable datalink ppp
interface <interface_name>
Set Command
set ppp
Disables the sending of an Accounting Stop record when a call is abnormally
disconnected before a Start Record is sent.
Disables PPP address field compression. The default is enabled.
Disables PPP protocol field compression. The default is enabled.
Disables strict checking of receive side ACCM mapping for incoming PPP data
packets. It checks whether all the control characters which need to be mapped are
mapped in all data packets.
Disables the administrative state of the PPP DLL created on top of the physical
WAN interface. You can list currently defined PPP datalink enabled interfaces using
the list ppp command.
Sets global parameters for PPP which applies to all calls including the call type for
which PPP compression will be attempted/accepted. Issuing this command
overrides the compression algorithm parameter set by the set network user
<user name> ppp command.
Users who dial in and receive a compressed_analog connection (MNP5 or V.42bis)
won't receive PPP compression. Payload compression is set by the parameter - not
header compression as set for a user.
The set ppp command has the following parameters:
authentication_preference [chap | default | eap | ms_chap | pap]
bap_hunt_group_phone_number <phone number>
ccp_modemtype_accept [none | all | digital | compressed_analog |
uncompressed_analog | pppoe]
dns_usage [system | ppp | none]
nbns_primary <ip address>
nbns_secondary <ip address>
pppdns_primary <ip_nbns_address>
pppdns_secondary <ip_nbns_address>
receive_authentication [none | pap | chap | any | eap | ms_chap |
any_except_mschap | encrypted_any]
session_start_message <string>
system_mtu <number>
These parameters are described in the following table.
Overview
17-3
Advertisement
Table of Contents
