Set Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

Set Commands

set ip
application_source_addre
ss [syslog | igmp | ping |
pptp_pac | traceroute | vtp]
<IP_address>
set ip defaultroute
gateway <IP_address or
name>et ip defaultroute
metric <hop count>
151.117.110.4/H
151.117.110.24
/
H
151.117.110.23/H
Specifies the source IP address (where packets exit) of an OfficeConnect Gateway
which has more than one Ethernet interface for IP routing or multi-home logical
networks configured on the Ethernet and which needs to communicate that
source address to an associated SYSLOG server. When configured (eth:1), the
source address (of UDP packets) overrides both the internal IP address and
autoconfigured IP system hosts address. The OfficeConnect Gateway Ethernet
addresses range in importance as follows:
Source IP address (highest priority)


Internal IP address


Default IP address (lowest priority).


When the IP address is configured at 0.0.0.0, this option is not set.
The show ip settings command displays this configuration.
These commands reconfigure a backup default route. The commands change the
address or metric of a primary default route with a gateway on the IP network
configured on the first OfficeConnect Gateway LAN interface (eth:1), and values
for a backup default route with a gateway on the IP network configured on the
second OfficeConnect Gateway LAN interface (eth:1).
A default route gateway specified with a higher metric acts as the primary default
route gateway and a second default route gateway with a lower metric acts as the
secondary default route gateway.
If one Ethernet interface goes down, the default route gateway associated with
that interface is disabled. If a second default route gateway associated with a
still-alive interface exists, that gateway will be installed as the primary gateway. If
the disconnected Ethernet interface is reconnected, the associated gateway will be
re-installed.
Parameters Description
<IP_address> IP address of the gateway router.
metric An integer representing how far away the default router is, in hops through
other routers. The range is 1-15. The default is 1.
LOCAL 147806 151.117.110.
4
LOCAL 147806 151.117.110.
24
LOCAL 147806 151.117.110.
23
Set Commands 12-17
0 eth:1
0 eth:1
0 eth:1