16
Overview
PPP Configurations
Configuring PPPoE
C
ONFIGURING
S
ETTINGS
This chapter describes how to use the CLI to configure the following WAN
protocols using the CLI:
Point-to-Point Protocol (PPP)
Point-to-Point Protocol over Ethernet (PPPoE)
Point-to-Point Protocol over ATM (PPPoA)
RFC 1483 (Multiprotocol encapsulation over ATM)
RFC 1483 - MER (MAC Encapsulated Routing over ATM)
Address Translation
Port Address Translation (PAT)
Network Address Translation (NAT)
VPNs (Virtual Private Networks)
PPTP
L2TP
IPSec
The CLI commands for configuring PPPoE and PPPoA are provided in the following
procedures.
To configure PPPoE from the CLI, perform the following steps:
1 To configure PPPoE you must enter a series of CLI commands.
The following example shows the CLI commands that are used to configure
PPPoE.
OCG-Adsl>>add profile <pppoe> network_service pppoec_atm_rfc1483
OCG-Adsl>>set profile <pppoe> send_password <root>
OCG-Adsl>>set profile <pppoe> bridging disable
2 Enter one of the following CLI commands next:
Enter the following CLI command to make the OfficeConnect Gateway
automatically negotiate with the Service Provider for an IP address:
OCG-Adsl>>set profile <pppoe> protocol ip
address_selection negotiate
If you know the specific local and remote IP addresses, enter the following CLI
command where
x.x.x.x
address.
Y
WAN P
OUR
is the local IP address and
ROTOCOL
is the remote IP
y.y.y.y