Table of Contents
Advertisement
17-2
C
17: PPP C
HAPTER
Add Command
add datalink ppp
Delete Commands
delete datalink ppp
interface <interface_name>
Enable Commands
enable datalink ppp
interface <interface_name>
enable ppp
acct_for_abnormal_disc
enable ppp address_field_
compression
enable ppp receive_accm
enable ppp
protocol_field_
compression
OMMANDS
Use this command to add a user to the PPP data link layer. This command has the
following parameters:
enabled [no | yes]
interface <interface_name>
profile <user_name>
Parameters
enabled
interface <interface_name>
profile
Removes the PPP data link layer defined on top of the physical WAN interface. You
can list currently defined PPP datalink enabled interfaces using the list ppp
command.
Enables PPP as the datalink layer protocol to run on the specified interface. You
must have previously run add datalink ppp in order for this command to work.
You can list currently defined PPP datalink enabled interfaces using the list ppp.
command.
Enables the sending of an Accounting Stop record when a call is abnormally
disconnected before a Start Record is sent.
Enables PPP address field compression. The default is enabled.
Enable strict checking of receive side ACCM mapping for incoming PPP data
packets. It checks whether all the control characters which need to be mapped are
mapped in all data packets.
Enables PPP protocol field compression. The default is enabled.
Description
Enable or disable the user.
Value is enabled or disabled.
The name of a valid interface. The limit is 32 ASCII characters.
A valid user name. The limit is 64 ASCII characters.
Advertisement
Table of Contents
