Disable Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

enable ip
address_pool_filtering
enable ip
address_pool_round_robi
enable ip forwarding
enable ip
multicast_heartbeat
enable ip network
<network_name>
enable ip rip
enable ip
source_address_filter
enable ip
static_remote_routes

Disable Commands

disable ip
Permits packet filtering on all IP address pools. Use the show ip command to view
the current setting
Turns on round robin allocation of IP addresses from IP address pools configured
with the add ip pool command. Use the show ip settings command to view the
current setting. The default is enabled
n
Allows all IP networks to forward (route) packets.
Enables multicast monitoring for a specified multicast group or interface.
Enables the specified IP network, which you previously defined using the add ip
network command. You can use the list ip networks command to see the
currently defined IP networks, as well as their current status.
Enables the RIP protocol for all IP networks. RIP protocol is set to NONE by default.
Enables filtering of packets that bear a source IP address other than that assigned
by the OfficeConnect Gateway during negotiations. This should not be enabled
for LAN-to-LAN routing. This feature works for PPP users. This feature is disabled
by default.
Enables statically defined remote routes, which are defined with the add ip route
command.
Disables the following IP parameters:
address_pool_filtering
network
send_host_unreach_for_pool
address_pool_round_robin
proxy_arp_all_dialin
send_unsolicited_arp
directed_bcast_forwarding
respond_to_directed_bcast
source_address_filter forwarding
rip
static_remote_routes
multicast_heartbeat
security_option
Disable Commands
.
12-9