Table of Contents
Advertisement
12-22 C
12: IP R
HAPTER
OUTING
set ip
source_based_routing
<interface_name> enabled
[no | yes]
set ip source route
<ip_name_or_net_addr>
Show Command
show all ip networks
show ip counters
C
OMMANDS
This command enables or disables source based routing on the specified interface.
Parameter
Description
interface_name
The name of the interface to which to apply this command.
enabled
no - Do not allow source based routing on this interface.
yes - Allow source based routing on this interface.
Change parameters in the routing table for the specified IP source route. This
command has the following parameters:
gateway <ip_name_or_addr>
metric <metric>
Parameter
ip_name_or_net_addr
gateway
metric
Displays details for all configured IP networks.
SHOW IP
Interface:
Network Address:
Frame Type:
Status:
Reconfigure Needed:
Mask:
Station:
Broadcast Algorithm:
Max Reassembly Size:
WAN Type:
Remote IP Address:
IP Routing Protocols:
IP Routing Metric:
RIP Interface Export
Metric:
IP RIP Routing
Policies:
IP RIP Authentication
Key:
Displays system-wide IP network statistics.
Input Counters
Description
The network name or IP address of the source route to be changed
The network name or IP address of the gateway to which IP
datagrams with the specified source address should be routed.
This specifies how many hops it is to the specified gateway.
NETWORK ip SETTINGS:
eth:1
151.104.196.166/C
ETHERNET_II
ENABLED
FALSE
255.255.255.0
151.104.196.166
IETF
8192
N/A
0.0.0.0
NONE
1
0
Advertisement
Table of Contents
