28-2
C
28: TFTP C
HAPTER
List Commands
list tftp clients
list tftp requests
OMMANDS
Value
get [remotefile]
[localfile]
help
mode [ascii | binary]
put [localfile]
[remotefile]
quit
rexmt
status
timeout
trace
verbose
?
For example, at the OCG-Adsl>> prompt, type:
tftp
ENTER
status
ENTER
The command lists:
Connected to status.
Mode: netascii Verbose: off Tracing: off
Rexmt-interval: 5 seconds, Max-timeout: 25
seconds
This section describes the following List-related TFTP commands:
list tftp clients
list tftp requests
The list tftp clients command displays IP addresses of all users allowed to use the
Trivial File Transfer Protocol (TFTP) to connect to the system. Use the add network
service command to add TFTP support to the system, the add tftp client
command to authorize users to connect, and the add tftp request command to
initiate TFTP service.
For example:
TFTP CLIENT addresses
0.0.0.0
157.122.138.134
234.122.156.134
The list tftp requests command displays statistics of all current requests for
service in the TFTP Client Request Table. It lists the following information:
Filename - Name of file to be requested from or sent to the TFTP server.
Server - Name or IP address of the TFTP server
Action - Type of request send to the TFTP server. Put or Get
Effect
Receive a file
Print help information
Set file transfer mode: ASCII or Binary
Send a file
Exit TFTP
Set the retransmission timeout interval. The range is 1-60. The
default is 5 seconds.
Show current TFTP request status
Set maximum timeout interval. The range is 1-300. The default is 25
seconds.
Toggle packet tracing
Toggle verbose mode echoes command
Display help information