Set Command; List Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

disable pppoe on
interface <interface_name>

Set Command

set pppoe

List Commands

list pppoe
list virtual connections
This command disables the specified interface from sending or receiving frames
carrying the new ether-type defined by the PPPoE protocol.
The set pppoe command sets the following parameters for PPPoE sessions
max_sessions <number>
max_sessions_per_host <number>
Parameter Description
max_sessions The maximum number of PPPoE connections that may be initiated
concurrently to the OfficeConnect Gateway by all hosts combined.
max_sessions_per_host The maximum number of PPPoE connections that may be initiated
concurrently by a single host to the OfficeConnect Gateway. This
helps to limit the Denial of Service attacks on the OfficeConnect
Gateway.
The list pppoe command shows information about PPPoE interfaces, service
names, and sessions. It has the following parameters:
bindings
service_names
sessions
These parameters are described in the following table.
Parameter Description
bindings This lists all the interfaces where PPPoE has been enabled and the status.
service_names The service name is typically the name of the ISP or any QOS
parameters.
Presently the service names are just strings with no QOS significance
attached. The client may send a service name as a NULL string indicating
that any service is acceptable in which case no service names need to be
configured in the OfficeConnect Gateway. If the client request contains
a non-null service name in the request, then the same name has to be
configured in the OfficeConnect Gateway.
sessions This command lists all of the existing PPPoE sessions and their peer
addresses in the concentrator.
Lists all of the PPP over Ethernet (PPPoE) connections coming into the
OfficeConnect Gateway as well as tunneled connections such as PPTP. This
command exists in addition to the list tunnel connections command which only
displays the virtual connections made by PPTP.
PPPoE Commands 18-3