Add Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

Add Commands

add ip defaultroute
gateway <IP_address or
name> metric <hop count>
Show show all ip networks
show ip counters
show ip rip counters
show ip
show ip settings
show ip network <network_name>
show ip network <network_name> settings
show ip routing
show ip routing settings
show all active interfaces
show all connections
show all filters
show all interfaces
show all ip networks
show all lan interfaces
show all networks
show command settings
show configuration, show configuration settings
show maximum_local_users
show memory
show memory utilization
show ip source_based_routing <interface_name>
show network <name>, show network settings
show packet_logging, show packet_logging settings
show session <user name>
show system, show system settings
Reconfigure reconfigure ip network <network name>
Allows a default route to be configured. The command adds a default route with a
gateway on the IP network configured on the OfficeConnect Gateway LAN
interface (eth:1), or on a PVC interface. This allows a default route to be
configured.
A default route gateway specified with a lower metric acts as the primary default
route gateway and a second default route gateway with a higher metric acts as
the secondary default route gateway.
If one interface goes down, the default route gateway associated with that
interface is disabled. If a second default route gateway associated with a still-alive
Add Commands 12-3