7
Overview
Voice Interface
Commands
Set Command
set voice interface
<name>
V
OICE AND
If your OfficeConnect Gateway is equipped to handle data and voice, you can use
it to receive both voice traffic and data traffic over your DSL line.
This chapter identifies the Voice and Voice over DSL (VoDSL) commands that can
be accessed from the CLI of the OfficeConnect Gateway. The information in this
chapter is organized into two sections:
Voice Interface Commands
VoDSL Commands
This section identifies and describes the Voice Interface commands accessible from
the OfficeConnect Gateway CLI. The following table identifies these commands:
Command
Command Name
Type
List
list voice interfaces
Set
set voice interface <name>
Show
show voice interface <name>
show voice interface
show all voice interfaces
Use this command to set the following parameters for a voice interface.
txgain <number>
rxgain <number>
state [closed | idle | voice | fax | dtmf | modem]
ring_frequency [alert_tone 1 | alert_tone 2 | alert_tone 3 | alert_tone 4 |
alert_tone 5 | alert_tone 6 | alert_tone 7 | alert_tone 8 | alert_tone 9 |
alert_tone 10 | alert_tone_silent]
ring_cadence [minus_r_ring | pattern_a_ring | pattern_b_ring |
pattern_c_ring | pattern_d_ring | pattern_e_ring | pattern_f_ring |
minus_t_ring | plus_r_ring | plus_t_ring | pattern_g_ring]
echo_canceller [enable | disable]
V
DSL C
O
OMMANDS