Table of Contents
Advertisement
Show Commands
show board settings
show configuration,
Parameters
transmit_authentication_name
The transmit authentication keyword (limit 64 ASCII characters) is used when the
OfficeConnect Gateway receives a challenge - typically during LAN to LAN or PPTP
routing - while making a PPP connection to a remote system/router over the WAN
(PPP requires a user at the datalink layer, which you supply here). Location, name
and contact names are limited to 64 ASCII characters.
The show board settings command displays the following information
associated with the processor (board) used in your OfficeConnect Gateway
configuration.
Product Code:
Card Type:
LAN Port MAC:
Expansion Port Number:
3Com Serial Number:
Flash Size:
SDRAM Size:
The show configuration command displays a variety of system information
including system, network, protocol, interface, forwarding, routing, DNS, host and
datalink parameters.
CONFIGURATION SETTINGS
System Identification:
Name: OfficeConnect
Gateway
Primary Server:
166.165.166.139
Remote Accounting:
ENABLED
Primary Server:
166.165.166.139
Interfaces:
eth:
slot:3/port:1
slot:3/port:1
internal
loopback
IP Forwarding: ENABLED
System Information Commands
Description
Remote account name.
Note: In LAN-to-LAN and PPTP connections,
this name must match the user name at the
far end of the connection.
GQ
ADSL Data Only
00209c1f25fa
ffff1f54ffff
XGQD61F25FA
4 MB
16 MB
Contact: Mike Hammer
Secondary Server:
0.0.0.0
Secondary Server:
0.0.0.0
eth:
slot:3/port:1
Routing: Enabled
3-5
:slot:3/port:1
RIP: ENABLED
Advertisement
Table of Contents
