Table of Contents
Advertisement
Displays a list of Telnet clients you configured using the add telnet client
list telnet clients
command. When access is globally enabled with the enable telnet client_access
command, Telnet clients on the list can access the OfficeConnect Gateway. By
specifying a netmask, you can add network and subnetwork addresses. If no
netmask is specified, the host netmask value is assumed. An IP address of 0.0.0.0
allows universal entry to the OfficeConnect Gateway by Telnet users. See the
delete telnet client command for more information. Also, issue the list telnet
client command for a list of configured users. The default is Disabled
Telnet CLIENT ADDRESSES
IP Address
148.132.112.23
148.132.112.45
enable telnet
The enable telnet command lets you enable the following Telnet parameters:
These Telnet parameters are described in the following table:
Parameter
client_access
disconnect_message
escape
terminal_
download_mode
trying_message
Also see the disable telnet and show time commands.
client_access
disconnect_message
escape
terminal_download_mode
trying_message
Description
Allows users to Telnet into OfficeConnect Gateway based on the
Telnet client access list. This command is used in conjunction with
the add telnet client command. See the list telnet client
command for settings. The default is Disabled.
When enabled, it sends connection closed by foreign host and
similar messages when the connection is closed. The default is
enabled.
All Telnet clients are permitted to use the escape character during
a session. By default the escape character is Ctrl] (right bracket). A
user can change that value using set_escape in the Telnet
program.
Turns off local and remote echo for Telnet on a TCP port other
than 23 for an OfficeConnect Gateway Telnet client. When
enabled, this function forces Telnet clients to negotiate Telnet
ECHO DISABLE for both local and remote sides of the connection.
The default is Disabled.
Turns on the trying status message for clients attempting to Telnet
out of the OfficeConnect Gateway. When escape is enabled,
Telnet clients who issue the escape character during their session
will get a local Telnet command line. This function is not supported
for login users.
Other Telnet Related Commands
Netmask
255.255.255.0
255.255.255.2
55
5-3
.
Advertisement
Table of Contents
