29-2
C
29: T
HAPTER
RACEROUTE
C
OMMANDS
Parameters
Description
<IP name or
IP name or address of destination to target. Maximum characters: 255.
address>
maxhops
Maximum number of hops traceroute runs before quitting. The default is
30. The range is 1-255.
port
UDP port number that the probe is sent to. The value should be an
unused port on the destination host. The default is 33434. The range is
1-65000.
retries
Number of times to attempt a given hop. The range is 1-10.
size
Amount of data in bytes to send in the traceroute packet. A larger data
size slows down performance and provides no additional information.
The default is 1. The range is 1-8184.
timeout
Interval in seconds before hop times out; not for completion of the
command. The default is 3. The range is 1-60.
A row will timeout after 30 minutes and automatically be deleted. Also, a row can
be deleted at any time, regardless of its state of status.
Be aware that traceroute-generated packets received by the OfficeConnect
Gateway will not increment ICMP error counters (Time Exceeded and Destination
Unreachable).
Error messages are generated for the following reasons:
DNS Failed - destination address could not be resolved due to timeout or
other reason
Bad address - resolved IP address is illegal
Hop Timeout - timeout occurred
Hops Exceeded - maximum number of hops exceeded
Dest(ination) Unreachable - a route to the host could not be found
Tracing - performing traceroute
Resource Failure - not enough resources to complete the command
The command will generate all information received up to resolution or failure.
HOP
address
1
154.112.254.24
2
154.112.254.254
3
154.112.124.254
4
154.112.170.2
5
154.112.79.1
6
154.112.63.253
7
153.234.24.145
8
137.039.037.067
9
Unknown
10
Unknown
11
Unknown
12
157.130.064.098
DEST UNREACHABLE
ROUND-TRIP-TIME
100
100
100
100
200
100
200
250
0
0
0
260