Bridging Commands; Configure Bridging For The Lan And Wan - 3Com OfficeConnect 3C100XF Cli User's Manual

6-2 C 6: B
HAPTER RIDGING

Bridging Commands

Configure Bridging for
the LAN and WAN
add bridge network
<network name>
list networks
list bridge networks
C
OMMANDS
The following table identifies the Bridging commands accessible from the
OfficeConnect Gateway CLI:
Command Command Name
Type
Add add bridge network <network name>
Delete delete bridge network <network name>
Enable enable bridge spanning_tree
Disable disable bridge network <network name>
disable ip forwarding
disable bridge spanning_tree
List list bridge networks
list bridge forwarding
Set set bridge aging_time <seconds>
set bridge forward_delay <seconds>
set bridge spanning_tree_priority <priority value>
set bridge firewall discard_routed protocols
set bridge firewall fwd_unicast_only
set bridge firewall fwd_bc_and_unicast
Show show ip settings
show bridge settings
show bridge network <name>
Remember to save your configuration using the save all command before
rebooting your OfficeConnect Gateway so that your changes will be written to
permanent FLASH memory.
To configure a protocol over the LAN, you need to assign a protocol network to
the LAN port by providing it with a name. After adding a network, you can modify
the advanced parameters.
Use the following CLI commands to configure bridging for the LAN and WAN:
Use the add bridge network <network name> command to add a bridge
network over the Ethernet interface.
Use the list networks command to obtain a list of all configured networks.
Use the list bridge networks command to only list bridge networks.