Icmp Commands; Overview; Enable Commands; Disable Command - 3Com OfficeConnect 3C100XF Cli User's Manual

14

Overview

Enable Commands

enable icmp
router_advertise
enable icmp logging

Disable Command

disable icmp
router_advertise
disable icmp logging
ICMP C
OMMANDS
This section describes the ICMP (Internet Control Message Protocol) commands
accessible from the CLI. In TCP/IP, ICMP the collection of messages exchanged by
IP modules in both hosts and gateways to report errors, problems and operating
information.
The protocol is used to report problems with delivery of IP datagrams within an IP
network. It can be used to show when a particular remote site is not responding,
when an IP network is not reachable, when a node is overloaded, when an error
occurs in the IP header information, etc. The protocol is also frequently used to
verify correct operations of remote sites and to check that routers are correctly
routing packets to the specified destination address.
The following table identifies the ICMP commands described in this chapter:
Command Command Name
Type
Enable enable icmp router_advertise
enable icmp logging
Disable disable icmp router_advertise
disable icmp logging
Show show icmp
show icmp settings
Enables OfficeConnect Gateway-generated router advertisements multicast on the
same LAN segment as the OfficeConnect Gateway.
Enables display of the Internet Control Message Protocol (ICMP) to the SYSLOG
server. Use the show icmp command to view edits. ICMP is disabled by default.
Disables OfficeConnect Gateway-generated router advertisements multicast on
the same LAN segment as the OfficeConnect Gateway.
Disables display of the Internet Control Message Protocol (ICMP) to the SYSLOG
server. Use the show icmp command to view edits. ICMP is disabled by default.