Enable Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

Enable Commands

enable link_traps
interface
enable security_option
snmp user_access
enable snmp
authentication traps
The parameters associated with this command are described in the following
table.
Parameter Description
<name> Pool name defining who can receive SNMP traps.
IP address list IP addresses of all SNMP managers associated with the pool, in the form
nnn.nnn.nnn.nnn.
See add snmp trap_community_pool and list snmp trap_community_pools
commands for more information.
This section describes the following Enable-related SNMP commands:
enable link_traps_interface


enable security_option snmp user_access


enable snmp authentication traps


The enable link_traps interface command informs SNMP to send linkup and
linkdown traps for the specified interface. We recommend you disable this feature
on all modem interfaces to eliminate a barrage of perfunctory awareness
messages forwarded from the NMC to the OfficeConnect Gateway alarm server
whenever modem states change or the OfficeConnect Gateway reboots.
The following parameter can be configured for this command
interface_name <eth:1>
Although the default is Disabled on modem interfaces, Hubs with Quad Modems
installed must have the OfficeConnect Gateway setting disabled manually to effect
the change. The command is enabled for Ethernet and WAN connections.
Also see the disable link_traps interface and show interface
<interface_name> settings commands.
The enable security_option snmp user_access command allows SNMP access
to the User Table. This lets remote users use SNMP to access the CLI and
reconfigure the OfficeConnect Gateway. Use the show security_options
command to see the current security values.
The enable snmp authentication traps command informs SNMP to send traps
for both local and remote authentication. The default is enabled
Also see the disable snmp authentication traps, and show snmp commands.
Enable Commands 25-5
.