Establishing Lan Connections; Set Nbx System-Wide Preferences; Change The Nbx Administrator Password - 3Com 3C10122 - NBX Business Telephone Installation Manual

104 C 2: I
HAPTER NSTALLING
Establishing LAN
Connections
Set NBX System-wide
Preferences
Change the NBX
Administrator
Password
S H C
YSTEM ARDWARE OMPONENTS
After you configure the NBX system IP settings, you are ready to connect
the system to your LAN.
1 Connect NBX system and any optional NBX chassis to your LAN using the
devices's Ethernet port.
The Ethernet port can operate at 10 Mbps and 100 Mbps; it
automatically senses the speed of your LAN. Check the status lights to
verify network connectivity:
V3001 Analog —
V3001 BRI — Figure 2
V3001R — Figure 3
V3000 Analog —
V3000 BRI — Figure 5
V5000 — Figure 6
Do not connect telephone lines or telephones yet.
Before you begin configuring devices, you should verify these default
settings:
1 Log in to the NBX NetSet utility using the default administrator username
and password:
administrator
00000000
2 Click
Telephone Configuration > System-wide Telephone Settings
To ensure system security, you should change the default administrator
password. There is only one administrator account on an NBX system.
CAUTION: If you change the administrator password, you cannot return
to the default, nor can you retrieve your new password if you forget it. If
you make any password changes, record them in a safe place.
To change the administrator password:
1 Log in to the NBX NetSet utility using as administrator.
2 Click System Maintenance > Password Administration.
Figure 1 on page 22.
on page 25.
on page 27
Figure 4 on page 30
on page 32
on page 34
.