Figure 57: Seating The Power Supply On The Internal Connector - Allied Telesis x950 Series Installation Manual

4. When the power supply makes contact with the connector inside the
switch, gently press on its faceplate to seat it on the connector. Refer
to Figure 57.
Figure 57. Seating the Power Supply on the Internal Connector
5. Visually inspect the power supply to be sure that its faceplate is flush
against the rear panel of the chassis.
6. If you purchased two AC power supplies for the switch, repeat this
procedure to install the second unit.
7. If you purchased a DC power supply as the second power supply, go
to "Installing PWR600 DC Power Supplies" on page 120.
8. To install an optional XEM2 Ethernet Line Card, go to "Installing an
Optional XEM2 Ethernet Line Card" on page 130.
9. After installing the power supplies and optional XEM2 Line Card, go to
one of the following chapters:
Chapter 6, "Installing the Switch on a Table" on page 135

Chapter 7, "Installing the Switch in an Equipment Rack" on page 139

Chapter 8, "Installing the Switch on a Wall" on page 147

Chapter 9, "Installing the Switch in the RKMT-SL01 Sliding Rack" on

page 163
x950 Series Installation Guide for VCStack
119