Figure 34: Seating The Power Supply On The Internal Connector - Allied Telesis x950 Series Installation Manual

Figure 34. Seating the Power Supply on the Internal Connector
5. Visually inspect the power supply to be sure that its faceplate is flush
against the rear panel of the chassis.
6. If you purchased two power supplies for the switch, repeat this
procedure to install the second unit.
7. To install an optional XEM2 Ethernet Line Card, go to "Installing an
Optional XEM2 Ethernet Line Card" on page 82.
8. After installing the power supplies and optional XEM2 Line Card, go to
one of the following chapters:
Chapter 5, "Installing the Switch on a Table" on page 87

Chapter 6, "Installing the Switch in an Equipment Rack" on page 91

Chapter 7, "Installing the Switch on a Wall" on page 99

x950 Series Installation Guide for Stand-alone Switches
81