Installing An Optional Xem2 Ethernet Line Card; Figure 72: Removing The Blank Line Card Cover - Allied Telesis x950 Series Installation Manual

Chapter 5: Installing Power Supplies and Optional XEM2 Line Card

Installing an Optional XEM2 Ethernet Line Card

130
This section contains the procedure for installing an optional XEM2
Ethernet line card in the expansion slot in the front panel of the
x950-28XSQ and x950-28XTQm switches. For background information,
refer to Chapter 2, "XEM2 Ethernet Line Cards" on page 51. The
illustrations show the XEM2-12XT Line Card. The procedure is the same
for all line card models.
Note
The x950-52XSQ switch does not support the XEM2 line cards.
Caution
The device can be damaged by static electricity. Be sure to follow
proper anti-static precautions when installing the device. Allied
Telesis recommends using a properly grounded wrist strap or other
personal anti-static device and an anti-static mat.
To install an XEM2 Ethernet line card, perform the following procedure:
1. Using a #2 Phillips-head screwdriver, loosen the two captive screws
on the blank expansion slot panel and remove it from the switch. Refer
to Figure 72.
Figure 72. Removing the Blank Line Card Cover
2. Carefully remove the new Ethernet line card from its shipping
container and anti-static bag. Refer to Figure 73 on page 131.