Configuring A Member Switch - Part I; Table 35: Configuring A Member Switch - Part I - Allied Telesis x950 Series Installation Manual

Chapter 11: Configuring Member Switches

Configuring a Member Switch - Part I

Step
1 Power on the member switch and wait two minutes for it to initialize the management
software. Refer to "Powering On a Switch" on page 192.
2 Start a local management session. Refer to "Starting a Local Management Session"
on page 196.
3 Enter the ENABLE command to move from the User Exec mode to the Privileged
Exec mode.
awplus> enable
4 Verify that the switch hardware is operating correctly, with the SHOW SYSTEM
ENVIRONMENT command. All components should have a status of Ok.
awplus# show system environment
Environment Monitoring Status
Overall Status: Normal
Resource ID: 1 Name: PSU Bay A (AT-PWR600)
ID Sensor (Units)
1 Device Present
2 Fan/Temperature Fault
.
212
The instructions for configuring a member switch are divided into two
parts. In Part I you do the following:
Display the hardware status with the SHOW SYSTEM

ENVIRONMENT command.
Display the firmware version number with the SHOW VERSION

command.
Enable VCStack with the STACK ENABLE command.

Set the switch ID number with the STACK RENUMBER command.

Add other member switches with the SWITCH PROVISION

command.
Save the configuration and reboot the switch with the WRITE and

REBOOT commands.
Allied Telesis recommends filling out the worksheet in "Stacking
Worksheet" on page 93 before performing the procedures.
To configure a member switch, perform the procedure in Table 35.
Table 35. Configuring a Member Switch - Part I
Description and Command
Reading Low Limit
Yes -
Yes -
High Limit Status
- Ok
- Ok