Ports 1 To 24 On The X950-28Xtqm Switch; Cable Requirements; Table 2: Twisted Pair Ports 1 To 24 On The X950-28Xtqm Switch - Allied Telesis x950 Series Installation Manual

Ports 1 to 24 on the x950-28XTQm Switch

Cable
Requirements
The specifications for twisted pair ports 1 to 24 on the x950-28XTQm
Switch are listed in Table 2.
Table 2. Twisted Pair Ports 1 to 24 on the x950-28XTQm Switch
Specification
Port Speed
Duplex Mode
Maximum Distance
Connector
Note
Network devices connected to the ports must be IEEE 802.3u
compliant.
The cable requirements are listed here:
100Mbps - Standard TIA/EIA 568-B-compliant Category 3

unshielded cabling.
1/2.5/5Gbps - Standard TIA/EIA 568-A-compliant Category 5 or

TIA/EIA 568-B-compliant Enhanced Category 5 (Cat 5e)
unshielded cabling.
10Gbps -Standard TIA/EIA 568-C-compliant Category 6a

unshielded cabling.
x950 Series Installation Guide for VCStack
Description
Here are the supported speeds:
- 100Mbps
- 1/2.5/5/10Gbps
Here are the guidelines to setting port
speeds:
- 100Mbps can be set manually or with
Auto-Negotiation.
- 1/2.5/5/10Gbps require
Auto-Negotiation.
The default port setting is
Auto-Negotiation.
Full-duplex only
100 meters (328 feet)
8-pin RJ-45
27