Powering On The Pwr600 Dc Power Supply; Figure 122: Connecting The Power Cord To An Ac Power Source - Allied Telesis x950 Series Installation Manual

Chapter 10: Configuring the Master Switch
Powering on the
PWR600 DC
Power Supply
194
Figure 122. Connecting the Power Cord to an AC Power Source
Note
If the switch has two power supplies, you do not have to power on
both of them to perform the procedures in this chapter.
4. If the switch has two AC power supplies, repeat this procedure to
connect a power cord to the second power supply.
5. If you have the PWR600 DC power supply installed on the switch, go
to "Powering on the PWR600 DC Power Supply" on page 194.
6. Wait two minutes for the switch to initialize its management software.
7. Go to "Starting a Local Management Session" on page 196.
To power on the switch with the PWR600 DC power supply, perform the
following procedure:
1. Verify that the DC power source unit that provides power to the switch
is powered off. If there are two DC power supplies, verify that both
units are powered off.
2. Verify that the DC power wires are connected to the PWR600 DC
supply.
3. Connect the other end of the power wire to the DC power source unit.
Refer to the documentation included with the unit for instructions.
4. Power on the DC power source unit.