Figure 148: Accessing The Connecting Screws; Figure 149: Front Panel Of The Pwr600 Dc Power Supply - Allied Telesis x950 Series Installation Manual

Figure 148. Accessing the Connecting Screws
5. Loosen all three screws for the ground wire, positive(+) and
negative(-) wires.
6. Remove all three wires.
7. Press the release lever to the right and pull on the handle to release
the power supply from the internal connector in the switch. Refer to
Figure 131 on page 191.
The release lever and handle are shown in Figure 149.
Release Lever
Figure 149. Front Panel of the PWR600 DC Power Supply
8. Carefully slide the power supply from the switch. Refer to Figure 150
on page 250.
Warning
The power supply is heavy. Use both hands to hold it when
removing it from the switch.
x950 Series Installation Guide for VCStack
Handle
249