Installing The Plywood Base - Allied Telesis x950 Series Installation Manual

Installing the Plywood Base

A plywood base is recommended when installing the switch on a wall that
has wooden studs. Refer to "Plywood Base for a Wall with Wooden Studs"
on page 151. Consult a qualified building contractor for installation
instructions for the plywood base. The installation guidelines are listed
here:
You should use a stud finder to identify the middle of studs and hot

electrical wiring in the wall.
You should attach the base to two wall studs with a minimum of

four screws.
The selected wall location for the base should adhere to the

recommendations in "Choosing a Site for the Chassis" on
page 104 and "Recommended Minimum Wall Area Dimensions" on
page 149.
x950 Series Installation Guide for VCStack
155