Chapter 9: Installing the Switch in the RKMT-SL01 Sliding Rack
180
Note
The long brackets have to be used between the fixed and short
brackets. You cannot connect them directly to the inner rails.
2. Assemble the extension brackets to match the selected length in the
table.
3. Attach the extension brackets to the inner rails. Observe the following:
Attach the brackets to the sides of the inner rails with the UP
arrows.
Attach the screws through the holes on the sides opposite the
sides with the UP arrows.
Caution
Use the extension bracket screws supplied with the inner rail. Using
screws other than those supplied may result in equipment damage.
E62
Figure 110 on page 180 shows an example.
Figure 110. Example of Attaching the Extension Brackets to the Inner
4. To test the lengths of the extension brackets, slide the inner rails into
the outer rails in the equipment rack. Refer to Figure 111.
Rails