Examples Of Port Numbering; Figure 18: Slot Numbers For Port Numbering - Allied Telesis x950 Series Installation Manual

Examples of Port
Numbering
Slot Number 1 for XEM2 Line Card:
You must include the PORT parameter when identifying individual ports,
and omit it from the last port when specifying ranges.
Figure 18 identifies the slot numbers for base ports and line card ports.
portn.1.n
Figure 18. Slot Numbers for Port Numbering
Here are examples of the PORT parameter in the INTERFACE command
for switches in a stack.
PORT Parameter on Base Ports
Ports on the switch are called base ports to distinguish from ports on an
XEM2 line card.
The first example enters the port Interface mode for base port 11 in a
switch with ID 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11
This example enters the port Interface mode for base port 4 to 7 in a
switch with ID 2:
Note
You have to include the PORT parameter when identifying individual
ports, and omit it from the last port when specifying ranges.
awplus(config)# interface port2.0.4-2.0.7
This example enters the port Interface mode for base port 10 in a switch
with ID 1 and base port 18 in a switch with ID 2:
awplus(config)# interface port1.0.10,port2.0.18
x950 Series Installation Guide for VCStack
Slot Number 0 for Base Ports:
portn.0.n
47