Designating Ports In The Command Line Interface; Figure 17: Port Parameter In The Command Line Interface; Table 13: Port Parameter Format - Allied Telesis x950 Series Installation Manual

Chapter 1: Overview

Designating Ports in the Command Line Interface

46
The individual ports on the switch are identified with the PORT parameter
in the command line interface of the AlliedWare Plus management
software. The format of the parameter is shown in Figure 17.
Switch ID Number
Figure 17. PORT Parameter in the Command Line Interface
The three parts of the PORT parameter are described in Table 13.
Table 13. PORT Parameter Format
Number
Switch ID Number
Slot Number
Port Number
port n.n.n
Slot Number
Port Number
Description
Identifies the switch's unique ID number in the
stack. When the VCStack feature is enabled,
switches display their ID numbers on the Switch
ID LEDs on the front panels.
Identifies whether ports are base ports or ports
on an XEM2 Line Card. Slot number 0 indicates
base ports and slot number 1 indicates ports on
a line card. Refer to Figure 18 on page 47.
Note
The x950-52XSQ switch has base ports
only.
Identifies a port number.