Figure 78: Holes For Bumper Feet; Figure 79: Inserting The Rivet Housing Into The Bumper Foot - Allied Telesis x950 Series Installation Manual

Chapter 6: Installing the Switch on a Table
136
Figure 78. Holes for Bumper Feet
Note
The following procedure assumes that you have already reviewed
the information and performed the procedures in Chapter 4,
"Beginning the Installation" on page 97.
To install the switch on a table, perform the following procedure:
1. Place the switch upside down on a table.
2. Inset a rivet housing into a bumper foot. Refer to Figure 79.
Figure 79. Inserting the Rivet Housing into the Bumper Foot
Rear of Chassis
Front of Chassis