Figure 145: Removing A Power Supply - Allied Telesis x950 Series Installation Manual

Chapter 14: Replacing Modules
246
Figure 145. Removing a Power Supply
6. Do one of the following:
To install a new power supply, refer to "Installing PWR600 AC

Power Supplies" on page 116 or "Installing PWR600 DC Power
Supplies" on page 120 for instructions.
If you are not installing a new power supply, continue with the next

step to install the blank panel
7. Orient the blank power supply cover as shown in Figure 146 on page
247 and slide it into the slot until it clicks into place.