Powering On A Switch; Powering On The Pwr600 Ac Power Supply; Figure 120: Connecting The Ac Power Cord - Allied Telesis x950 Series Installation Manual

Chapter 10: Configuring the Master Switch

Powering On a Switch

Powering on the
PWR600 AC
Power Supply
192
The procedure in this section explains how to power on the switch. If you
have not installed the power supplies, refer to "Installing PWR600 AC
Power Supplies" on page 116 or/and "Installing PWR600 DC Power
Supplies" on page 120 for instructions.
Before powering on the chassis, review the information in "Power
Specifications" on page 268.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.  E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible.  E5
To power on the switch with the PWR600 AC power supply, perform the
following procedure:
1. Connect the AC power cord included with the power supply to the AC
power connector on the rear panel of the chassis. If the switch has two
power supplies, you only need to power on one of them to configure
the switch. Refer to Figure 120.
Figure 120. Connecting the AC Power Cord