Table of Contents
Advertisement
4. When the power supply makes contact with the connector inside the
switch, gently press on its faceplate to seat it on the connector. Refer
to Figure 50.
Figure 50. Seating the Power Supply on the Internal Connector
5. Visually inspect the power supply to be sure that its faceplate is flush
against the rear panel of the chassis.
6. If you purchased two power supplies for the switch, repeat this
procedure to install the second unit.
7. To install an optional XEM2 Ethernet Line Card, go to "Installing an
Optional XEM2 Ethernet Line Card" on page 100.
8. After installing the power supplies and optional XEM2 Line Card, go to
one of the following chapters:
Chapter 5, "Installing the Switch on a Table" on page 105
Chapter 6, "Installing the Switch in an Equipment Rack" on page 109
Chapter 7, "Installing the Switch on a Wall" on page 117
x950 Series Installation Guide for VCStack
99
Advertisement
Table of Contents
