Table 33: Configuring The Master Switch- Part Ii - Allied Telesis x950 Series Installation Manual

Chapter 10: Configuring the Master Switch
Table 33. Configuring the Master Switch- Part II (Continued)
Step
Enter the port Interface modes of the ports that will be the stack trunk on the master
5
switch. This example assumes the master switch will use ports 33 and 37 as the stack
trunk. Be sure to modify the command to specify the ports for your stack trunk.
awplus(config)# interface port1.0.33-1.0.37
Designate the ports as trunk ports with the STACKPORT command.
6
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Return to the Global Configuration mode.
7
awplus(config-if)# exit
Steps 8 designates the types of transceivers to be used in ports 25, 29, 33, and 37 for the
x950-28XSQ and x950-28XTQm switches or in ports 49, 53, 57, and 61 for the x950-52XSQ
switch on the provisioned member switches. The ports support 40Gbps QSFP+ transceivers,
100Gbps QSFP28 transceivers, and 40Gbps to 10Gbps breakout cables. The default is
40Gbps QSFP+ transceivers.
Configure ports 25, 29, 33, and 37 for the x950-28XSQ and x950-28XTQm switches
8
or in ports 49, 53, 57, and 61 for the x950-52XSQ switch on the provisioned member
switches for the appropriate transceivers, with the PLATFORM PORTMODE
INTERFACE command. For more information, refer to "Ports for 40Gbps QSFP+ or
100Gbps QSFP28 Transceiver, or Breakout Cables" on page 29 and "PLATFORM
PORTMODE INTERFACE" on page 188.
This example assumes a stack with three member switches (port2 to port4) that will
use 100Gbps transceivers in ports 33 and 37:
awplus(config)# platform portmode interface port2.0.33-2.0.37 100g
awplus(config)# platform portmode interface port3.0.33-3.0.37 100g
awplus(config)# platform portmode interface port4.0.33-4.0.37 100g
Steps 9 and 10 designate the stack ports on the provisioned switches with the STACKPORT
command.
Enter the port Interface modes of the ports that will be the stack trunk on the
9
provisioned member switches. This example assumes the stack will have three
member switches and the stack ports are 33 and 37. Be sure to modify the command
to specify the ports for your stack trunk.
awplus(config)# interface port2.0.33-2.0.37,port3.0.33-3.0.37,
port4.0.33-4.0.37
204
Description and Command