Replacing Fan05 Modules; Removing Fan Modules; Figure 151: Loosening The Screws On The Fan Module - Allied Telesis x950 Series Installation Manual

Replacing FAN05 Modules

Removing Fan
Modules
This section contains the procedure for replacing FAN05 Modules. Fan
modules are hot swappable. You can replace them without having to
power off the switch. For background information, refer to "FAN05 Cooling
Fan" on page 45.
Note
Allied Telesis recommends saving a backup copy of the
configuration file in the switch before replacing a fan module. For
instructions, refer to the Software Reference for x950 Switches.
This procedure requires the following tool:
#2 Phillips-head screwdriver (not provided)

The illustrations show the removal of the fan module from FAN B slot on
the back panel. The procedure is the same for removing a module from
FAN A slot.
To remove a fan module from the switch, perform the following procedure:
1. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the fan module. Refer to Figure 151.
Figure 151. Loosening the Screws on the Fan Module
x950 Series Installation Guide for VCStack
251