Verifying The Stack; Figure 126: Show Stack Command - Allied Telesis x950 Series Installation Manual

Verifying the Stack

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
To verify the stack, perform the following procedure:
1. Start a local management session on any switch in the stack. Refer to
"Starting a Local Management Session" on page 196.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
An example of the command for a stack of four switches is shown in
Figure 126.
MAC address
e01a:ea20:8011
e01a:ea20:ee45
e01a:ea20:8a98
e01a:ea20:1b67
Figure 126. SHOW STACK Command
Review the following items:
The command should list all the switches. If the list is incomplete,

refer to Chapter 15, "Troubleshooting" on page 257.
The Operational Status field should be "Normal operations" to

indicate that all the trunk ports are operating normally.
If the Operational Status field is displaying "Not all stack ports are

up," one or more trunk ports are not being used or cannot establish
links with their counterparts. For more information, refer to Chapter
15, "Troubleshooting" on page 257.
3. Go to Chapter 13, "Cabling the Networking Ports" on page 225, to
complete the installation.
x950 Series Installation Guide for VCStack
Priority Status
1 Ready
2 Ready
3 Ready
4 Ready
Normal operations
0015:774f:ed30
Role
Active Master
Member
Member
Member
223