Configuring A Member Switch - Part Ii - Allied Telesis x950 Series Installation Manual

Configuring a Member Switch - Part II

Step
1 Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 196.
2 Enter the ENABLE command to move from the User Exec mode to the Privileged
Exec mode.
awplus> enable
3 Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Change the switch's priority to match its ID number, with the STACK PRIORITY
4
command. This example sets priority to 2 on a member switch with the ID 2:
awplus(config)# stack 2 priority 2
This section contains the second part to configuring member switches.
The steps show how to configure the following parameters:
Set the priority number of the switch to match its ID number, with

the STACK PRIORITY command.
Specify the types of transceivers to be used in slots 25, 29, 33, and

37 for the x950-28XSQ and x950-28XTQm switches, or in slots 49,
53, 57, 61 for the x950-52XSQ switch on the master and member
switches with the PLATFORM PORTMODE INTERFACE
command.
Designate the ports of the stack trunk with the STACKPORT

command. Refer to "Stack Trunks" on page 74.
To configure a member switch, perform the procedure in Table 36.
Table 36. Configuring a Member Switch - Part II
Description and Command
x950 Series Installation Guide for VCStack
215