Figure 33: Seating The Power Supply On The Internal Connector - Allied Telesis 950 Series Installation Manual

Figure 33. Seating the Power Supply on the Internal Connector
5. Visually inspect the power supply to be sure that its faceplate is flush
against the rear panel of the chassis.
6. If you purchased two power supplies for the switch, repeat this
procedure to install the second unit.
7. To install an optional XEM2 Ethernet Line Card, go to "Installing an
Optional XEM2 Ethernet Line Card" on page 76.
8. After installing the power supplies and optional XEM2 Line Card, go to
one of the following chapters:
 Chapter 4, "Installing the Switch on a Table" on page 81

Chapter 5, "Installing the Switch in an Equipment Rack" on page 85

Chapter 6, "Installing the Switch on a Wall" on page 93
x950 Series Installation Guide for Stand-alone Switches
75