Chapter 6: Installing The Switch On A Table; Figure 77: Parts Of The Bumper Feet - Allied Telesis x950 Series Installation Manual

Chapter 6
Installing the Switch on a Table
This chapter contains the instructions for installing the switch on a table or
desktop.
Warning
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches.  E91
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
The switch comes with seven bumper feet in the accessory kit. The feet,
which are reusable, are used when installing the switch on a table. If they
are already assembled, disassemble them by removing the rivets and rivet
housings from the bumper feet. Refer to Figure 77.
Figure 77. Parts of the Bumper Feet
The holes in the base of the switch for the bumper feet are shown in Figure
78 on page 136.
Rivet
Rivet Housing
Bumper Foot
135