Preparation; Lubricant And Coolant; 4Wd Propeller Shaft And Power Steering Hose - Kubota M8540 Workshop Manual

M8540, M9540, WSM

[2] PREPARATION

(1) Lubricant and Coolant

(2) 4WD Propeller Shaft and Power Steering Hose

Draining Coolant and Engine Oil
1. Refer to "7. CHECK
LUBRICANTS, FUEL AND COOLANT" at "G. GENERAL"
section.
Propeller Shaft
1. Slide the propeller shaft cover (3) after removing the screw (8).
2. Tap out the roll pins (2) and then slide the coupling (1) to the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
• Tap in the roll pins (2) as shown in figure.
(1) Coupling
(2) Roll Pin
(3) Propeller Shaft Cover
(4) Roll Pin
Power Steering Hose
1. Disconnect both power steering delivery hoses (2) from power
steering cylinder (1).
(When reassembling)
• Connect the power steering hose with blue tape to the R.H..
Power steering delivery
Tightening torque
hose nut
(1) Power Steering Cylinder
1-S25
AND MAINTENANCE" and "4.
(5) Propeller Shaft
(6) Cover
(7) Coupling
(8) Screw
23 to 27 N·m
2.3 to 2.8 kgf·m
17 to 20 lbf·ft
(2) Power Steering Delivery Hose
KiSC issued 09, 2008 A
ENGINE
W1051987
W1027651
W1055595