Preparation; Separating Engine And Clutch Housing - Kubota L2800 Workshop Manual

L2800, L3400, WSM

[2] PREPARATION

(1) Separating Engine and Clutch Housing

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plugs (1) to drain oil.
4. Screw in the drain plugs (1).
(When refilling)
• Fill the engine oil up to the upper line on the dipstick (2).
IMPORTANT
• Never mix two different types of oil.
• Use the proper SAE
temperatures.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.
Engine oil
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet Plug
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. Loosen the drain plug (2) to drain the coolant.
3. Remove the radiator cap (1) to completely drain the coolant.
4. After all coolant is drained, retighten the drain plug (2).
Coolant
(1) Radiator Cap
1-S19
Engine Oil according to ambient
6.0 L
Capacity 5.7 U.S.qts
5.0 Imp.qts
A : Oil level is acceptable within this
range.
6.0 L
Capacity
6.3 U.S.qts
(with recovery tank)
5.3 Imp.qts
(2) Drain Plug
ENGINE
W1050040
W1048932
KiSC issued 08, 2007 A