Projector Covers And Feet; Removing The Top Cover; Removing The Rear Cover - Christie HS 2K Series Service Manual

Projector covers and
feet
Learn how to remove the covers and feet of the projector.

Removing the top cover

The top cover and top shielding provide access to the main board and other components.
1. On the rear cover side, remove the three captive screws with a Phillips #1 screwdriver.
2. Slide the top cover towards the front of the projector and lift it.
3. Remove the top cover.
4. If required, replace the top cover.
5. To re-install the top cover, follow these steps in reverse order.

Removing the rear cover

The rear cover provides access to 3D SYNC and other signal.
1. Remove the top cover.
See Removing the top cover
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
59