Display Ppp Mp - H3C MSR Series Command Reference Manual

Field
Output: 0 packets, 0 bytes, 0 drops
Brief information on interface(s) under
route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause
Related commands
reset counters interface virtual-template

display ppp mp

Use display ppp mp to display MP information for MP-group interfaces.
Syntax
display ppp mp [ interface mp-group interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Description
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped outgoing
packets.
Packet statistics are not performed for VT interfaces.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
•
Stby—The interface is operating as a backup interface. To see the
primary interface, use the display standby state command in
High Availability Command Reference.
Indicates the network layer protocol state of an interface is UP, but its
link is an on-demand link or is not present.
Abbreviated interface name.
Physical link state of the interface, which can only be DOWN for VT
interfaces.
Line protocol state of the interface, which can only be DOWN for VT
interfaces.
Primary IP address of the interface.
Interface description configured by using the description command.
Without the description keyword, the display interface brief
command displays at most 27 characters of the description.
Causes for the physical state of the interface to be Down.
Not connected indicates no physical connection exists (possibly
because the network cable is disconnected or faulty).
20